Smooth Wall & Paint
Smooth Wall & Paint is an innovative premium one coat system, combining the characteristics and performance of a high solids level 5 acrylic coating, primer, and flat finishing paint all-in-one.
What is it?
Smooth Wall & Paint is designed for use over interior gypsum wallboard or interior concrete surfaces, and can be spray applied, or rolled-on to achieve a combined one coat level 5 fnish and top-coat fnish system. Smooth Wall & Paint hides minor defects and reduces variations, and may be used in lieu of a trowel or spray applied skim coat, primer coat, and fnish paint coat combined.
Benefits:
Smooth Wall & Paint is a low odor, zero VOC, and acrylic based. It has excellent sprayability, sag resistance, wet and dry hide, is smooth, dries fast, and produces a high build ultra-flat finish. It exhibits excellent adhesion to wallboard, primers, and concrete surfaces, and has good water resistance and scrub resistance. Smooth Wall & Paint’s alkali resistance (up to pH 13) allows for seven day old (’hot’) and older concrete to be coated.
Simple Application
Step 1
Prepare a level 3 wall.
Step 2
Spray 1st coat of smooth wall.
Step 3
Spray 2nd and final coat of smooth wall. Allow at least 60-90 minutes dry time between coats.
Step 4
Touch up as needed just like normal paint, with a brush, roller or sprayer.
Video
Data Sheet
Hamilton Smooth Wall & Paint Product Data Sheet
1. Packaging: 65 lbs. (29.48 kg) net weight in 5 gallon plastic pails. Protect from direct sunlight and keep from freezing. Do not stack more than 3 pails high. Shelf life of 6 months.
2. Coverage: Approximately 600-1200 square feet per 4.5 gallon pail, depending on application and wet film thickness.
3. Thinning: Do not thin product.
4. Mixing: Mix well before using.
5. Drying Time: Dry to touch in approximately 15-30 minutes at 68°F (20°C) and good ventilation. Allow at least 60-90 minutes dry time between coats.
6. Clean-Up: Wash tools and equipment with water.
7. Job and Surface Conditions: Substrate must be dry, clean, sound, and free from contaminants such as dust, oil, mildew, debris, and efflorescence. Minimum air, mix and surface temperatures of 50°F (10°C) must be maintained within working areas until product is completely dry.
MASONRY, CONCRETE, AND PLASTER: Surfaces should cure for a minimum of 7 days prior to application.
8. Application: Full coverage coat with airless sprayer capable of 1 gallon per minute at 2700-3000psi with .019”-.031” tip is the preferred method of application.
Application options include:
- Spray only: Spray 6-12 mils wet lm thickness (WFT), depending on application and performance requirements.
- Spray & Roll-on: Spray 4-7 mils WFT, depending on application and performance requirements. Allow at least 60-90 minutes dry time. Using 1/4” to 1⁄2″ roller depending on desired smoothness, apply 3-4 mils WFT.
- Roll-on: Using a ¼” to 1⁄2″ roller depending on desired smoothness, apply two coats at 3-4 mils WFT per coat. Allow at least 60-90 minutes dry time between coats.
Let's Build Something
Call or email us anytime and we will get back to you!
info@www.gracesupply.com
12006 Slide Road, Lubbock, TX 79424
+1 (806) 217-7180
